Interested to Buy Any Domain ? << Click Here >> for more details...
why we use CVT (capacitive voltage transformer)in switch yard?
- 5 Answers
- 15852 Views
- I also Faced
- E-Mail Answers
Answer Posted / pandu
simply we use cvt.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
How i can decide that HVDC line is best for transmission.
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
what is meant by impedance & transient protection?
what sort of general awareness questions are asked in o.n.g.c entrance exam?????????????????
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
Why the output of OP-AMP is always less than Vcc?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
What is power relay?
What is the phase relationship between the primary and secondary voltages of a transformer?
why would amp draw on neutral wire be as much as amp draw on the hot leg.
