what is the need of reactor in between the transmission line?..like powergrid like that..
- 5 Answers
- 3784 Views
- Delta Roto Tech, I also Faced
- E-Mail Answers
Answer Posted / irfankh
to limit short ckt current, for that we use reactors
formula:
Ish=v/xL
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
suri transmission
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
What are the advantages of the three-phase motor over single phase motor?
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
how to calculate the lightning arrester conductor @ no of earth pits required
WHAT HAPPENED DC SERIES MOTOR FIELD WINDING OPEN. CAN POSSIBLE.
a starter used for squirrel cage induction motor?
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What are gain margin and phase margin?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
How earthing of switchgear system to be done.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
