why when i start my diesel generator it takes 1 minute or less then stop, and i checked the oil sensor is ok and when the generator start i can get 220 voltage but it it is stop after 1 minute or less, how can i solve this problem?
- 1 Answers
- 1930 Views
- I also Faced
- E-Mail Answers
Answer Posted / m.r.chaudhari
Check bettery & bettery charger.
When bettery is discharge due to not working properly battery charger.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?
i have a 1500kVA transformer what is the kWH meter i need to use?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
why there using acb enclosure in big buildings
how generator load test is conducted?what are the steps?
Please brief working principle & construction of permanent magnet AC Servo motor
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What is critical disruptive voltage?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is a power factor?
what is integrated ac contact circuit
What is open delta Xformer? It's adavntages & Use?
witch pump used in wtp
