can any one explain me the where is the use of plc and scada
- 4 Answers
- 4643 Views
- I also Faced
- E-Mail Answers
Answer Posted / tarun aggarwal ymca
PLC: PLC is a Micro Processor based Electronic Device which is used to control certain process according to predefined programs which are saved in the PLC.
These programs can be change or modified as per the requirement.
SCADA: as its name Implies Supervisory Control and Data acquisition, is used for monitoring and controlling of Processes which displayed graphically.
Through SCADA we can do just small changes during the execution of process ( e.g, we can change only value of variables).
Also it gives feature like storing, and can communicate to other servers.
Here programming is done in Scripting language.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
IN 1000kva transformer where the oil and winding temperature sensors is connected
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
What test must you do before powering up a circuit that you have been working on?
what are the parameters plays a major role in Potential transformer Burden calculation??
What is frantic effect?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
what is the transformer turn ratio formula and give some examples?
What is phenomenon of electromagnetic induction and how it works?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
Can we use Ccapacitive voltage transformer directly for metering purpose?
What are locations arc protection relay is fixed.
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
What are the uses of lead compensator?
What is Bolted fault?
in shunt clippers why a resistor is used in sereis with the input
