Interested to Buy Any Domain ? << Click Here >> for more details...
In my home i am getting too much electricity bill (more than 4000) but I am very much sure that we are not consuming that much. How i can check this ?
- 6 Answers
- 6036 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Lodge a complaint with the supplier ,you may have to pay the testing charges
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Can we transmit digital signal to long distance ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
What is a signal flow graph?
how to do the ductor test?
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
how to compute kAIC? with formulas...
How many double suspension hardware fittings are required on a double circuit transmission tower?
What test must you do before powering up a circuit that you have been working on?
why using transformer and thyristor switch in 3 phase apfc panel
What are n circles?
How isolater function when installed inelectrical 440V wiring
Explain Circuit Breaker Trip Characteristics in detail.
