what is difference between 1/2"NPT & M20 x 1.5 cable gland?
- 8 Answers
- 86277 Views
- I also Faced
- E-Mail Answers
Answer Posted / am i nuts?
NPT is for piping and ISO M20 X 1.5 is an electrical standard.
| Is This Answer Correct ? | 1 Yes | 15 No |
Post New Answer View All Answers
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
What is the start up procedure of desalter
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
how to calibrate load cell
How to erection of DCS Panel at site step by step
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
What is eddy current? Describe the operating principle of proximity probe.
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
how to work MIL contol valve posistioner ?
How to decrease opening & closing time of on/off valve?
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
What are different types of orifice plates?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
