why use to 250 ohm for hart protocol and why hart communicator not communicate without 250 ohm
- 4 Answers
- 14909 Views
- OMV, I also Faced
- E-Mail Answers
Answer Posted / saurabh singh
1-5 volt standard voltage for hart operation.
4-20 ma standard current signal
When 4ma* 250v= 1 volt
20ma* 250v = 5 volt
At 5 volt hart comes in operation.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
Dear Sir/Madam,im going to attend Hpcl written exams on feb 17th in instrumentation stream..can anyone send me the HPCL model papers and pattern of HPCL ....i ve not yet attended anything in HPCL...so i dont know how it comes...so just i need some model test papers and pattern ..pls help me friends...
What is the start up procedure of desalter
In Safe Guarding test what means by "Failed to Danger" ?
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
What is the meaning of wet leg
what is the different between deflection type measurement and null type measurement in RTD?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
why is an oxygen sensor used in a boiler stack
what about your moleg in pogrees with company
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
please send the sample qustion paper for iocl written test ..
