How can i modify the design of 3 phase induction motor to
be as 3 phase synchronous motor??
Answer Posted / jaaaan
In induction motor armature winding is connected as closed loop
In syncronous motor armature winding is connected the dc supply
We are just connect the dc supply to the armature supply throuh the slip rings
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
what is v/f control in VFD?
if we have 320KVA Genset kindly advice how much load we can put it.
Draw a SLD of DG distribution up to main LT panel?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
How to select HT/MV cable size ?
What are the protections for safe running of electric generator?
Where voltage are high and current to be interrupted is low the breaker preferred is:
Why a tesa lamp is glow between two phase?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
What is the necessary and sufficient condition for stability.
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
Hi everyone. Some Generators uses 3-Pole breakers with extra contactors for Neutral. Some uses 4-Pole. Why so? What is the idea behind this? Thanks in advance for the solution. Kr.