different between circuit breaker & switchgear & relays
Answer Posted / amol payghan
Relay is used to detect the fault condition and initiate the operation of the circuit breaker.
Circuit beaker is used to disconnect/isolate the faulty circuit from the bus bar system.
Switchgear are the apparatus used for switching, controlling and protecting the electrical circuit and equipements
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
why transformer tank is in rectangular shape what happen when it is in step shape
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
mention hazard experienced during installation
why is the conservator tank painted white on the transformer
3phase motor can be used as a Prime mover for alternator.
what is High resistance grounding and whatis the criteria for the selection of High resistance grounding
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
What are Contactors? How they works and what its highest rating?
Grid fault level [KA]?
Why is the starting current high in dc motor?
What is time response of the control system?