Why is modification of signal required for transmission
Over channel?
Answer Posted / divya
when signal is transmitted for long distances ,the signal will be corrupted of noise so we need the original signal,to get that (we add carrier signal and send it i.e modulation is done) nothing but we amplify the signal
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A channel has a bit rate of 4kbps and a propagation delay of 20msec. For what range of frame sizes does stop-and-wait give an efficiency of at least 50%
Why memory width is not 16-bit? In stead of having 8-bit in 8085?
How to make a robo car .Please give me whole theory ,photos of circuits etc. on my e-mail id.
I am studing Diploma Electronics from International Council for Management Studies-CHENNAI. Is it useful for getting engineering job within india or international ?
What is the use of starter and choke in tube
why we using different type of microwave antenna we using like one is connected to MMU and one more is connected to other slot what is use of both antenna?
im an electronics and communication engineering..i have to attend an interview based on contract basis.i kindly request u to send all possible questions to my mail. MY EMAIL ID IS -ashishkashyap931@gmail.com
What do you understand by collector reverse saturation? In which configuration does it have a greater value?
i want BHEL electronics and communication placement papers.
When we trim a resistor, we are A Making a fine adjustment B Reducing its value C Increasing its value D Making a coarse adjustment
What is inductor?
what is receiver device in ir receiver which catch over signal of ir?
numerical on total power transmission in AM
checking procedure of i.g.b.yt & diode by multimeter...
plz post the ne questions for electronics engg interview