how to check the continuity of a cable with a megger
Answer Posted / sanjayjssate
its very simple
Connect the other ends of cable togather and take megger from other end at very low voltage, if megger is zero means it is continuty is one, again seprate the the cable and take the megger if megger is more tha 100 Kohm, means cable is healthy.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is level 2 automation?
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
what are symmetrical and non symmetrical components in electrical installation.
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
Minimum IR value of 1.1 kv grade 3.5c (300, 240,185,150,120,95,70,50,35,25) sqmm Aluminium XLPE cable and 4c (16, 10,6 & 4) sqmm cu arm cable between RY,YB,BR,RN,YN,BN,RE,YE,BE & NE.
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
role of europe union in UK safety legistlation (electrical safety)
How can we increase the capacity of Energy.?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
why co incidence factor considered in transformer sizing?
What is pd controller?
what is the relation between size of the anteena and wavelenghth of radiated wave
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?