I have 320 Kva DG Set his KWh running is 77 , how i can calculate into electrical unit .
- 2 Answers
- 2814 Views
- Anuj Enterprises, Schneider, I also Faced
- E-Mail Answers
Answer Posted / aruniscool
You should know the meter constant that's the ct ratio used to measure than u will get the reading.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
the winding of Generator and Motor is star or in delta ? and why
please send previous exams question papers
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
what is the minimum voltage require to injure our body?
Pl.brief me any electrical major fault you have rectified.
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is notching in dc machine?
What is the difference between hot and cold loop testing?
what is meant by impedance & transient protection?
