Hi,
My question is our total motor load is 55 kw.so what cable size required for main supply. Please reply
Answer Posted / aruniscool
Can use 25 sq mm copper 3 core or
50 sq mm aluminium 3 core
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How is the percentage impedence of a transformer fixed at design stage???
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
mccb service sittings be done?
write down the formula of cable size in RM if current is 50Amp.
If 24 KVA AVR having Input voltage 200-400v, Output voltage 415+-1%, what will be the voltage if Load is 13A.
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
Why Ac Systems Are Preferred Over Dc Systems?
I WANT TO INSTALL LIGHTING ARRESTOR ABOVE 20 FEET HEIGHT INDUSTRIAL BUILDING. NOW IT WAS 15 FEET HEIGHT HOW MUCH DISTANCE IT WILL COVER & HOW TO CALCULAT THE DISTANCE COVER BY THE ARRESTOR
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
How to test Alternator stability test for REF relay
how to calculate fault level?