Answer Posted / santosh mali
Barriers are used in only hazardous area,and for safety purpose.it is also used in distillation plants and for isolation.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Tell about your IFFCO plant visit.
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
selection of the zener barrier for the hazardeous area zone 0
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
What are different types of cable?
Pl send the model question paper of mahagenco account officer post
What is difference between radial vibration and axial vibration explain in detail .
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
How d.p. Transmitter can be applied to close tank?
key phaser where is use and work
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
Calibration procedure for Electro magnetic Flow meter