our company have 750 kva oil transformer.still we have
facing a problem that is when voltage is 11.5 kv coming
from HT side then LT-side voltage is 420v or above at tape
1.please give me best solution to decrease the voltage.
- 3 Answers
- 4190 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjayjssate
File a case against the seller if transformer values are different than those mentioned on specification plate.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
HOW TO CALCULATE HV CABLE SIZING?
what type of questions are asked and howmwny questions belong this catagory?
how to calculte capacitor range for single phase induction motors??pls tel
what is excitation/
why moisture formation found in XLPE Armoured cable outer sheath
What is a copper loss or i2r loss pc?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
What is the RME and explain the full form and what is the RME work?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
How will change the frequency in distribution side?
what could be the RMS value and average value of a 4 phase sine wave?
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
How to calculate wire length,size & current? ( related to control panel)
