Interested to Buy Any Domain ? << Click Here >> for more details...
waht is difference between pressure transmitter and
transuducer
- 4 Answers
- 7757 Views
- Gasco, I also Faced
- E-Mail Answers
Answer Posted / vinodkumar
A transducer is a device which converts one form of energy into another. But a transmitter is a device which is composed of a series of transducing stages to give output as industrial standard signals. The industrial standard signals are pneumatic (3 - 15psig), electrical (4 - 20 mA). there are three types of transmitters. Pneumatic transmitter, Analog Transmitter and Digital Transmitter
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
Explain pH, Conductivity.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How to erection of DCS Panel at site step by step
why is an oxygen sensor used in a boiler stack
Pl send the model question paper of mahagenco account officer post
Please asked me How calculate DCS controller memory.
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
How oil line flow measured?eplain about instruments used and working principle?
How the sizing of the analog signal cable is calculate?
In turbine what does term CDP, NH, HSSOC means.
why we take %i0.0 as input for twido plc
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
