What is the knee point voltage of CT-100/5,15VA,5P20 ?
- 3 Answers
- 6126 Views
- ERL, NTPC, I also Faced
- E-Mail Answers
Answer Posted / rams dharavath
Knee point is very important factor to choose a CT . It is the voltage at which a CT gets saturated.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
working principles of cf lamp,incandescentlamp and f lamp?
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
Can you explain about Restricited earth fault protection scheme
boiler is running in rankine cycle and deisel generator is....?
how can decide the current rating of oltc
why we are not giving the zone 1 trip command to the master trip relay
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
What are the advantages of hydropower?
what is difference between speed mode and torque mode in motor?? explain in simple words please.
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
for 750 kw LT load what will be the ht kva
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
he compression ratio for a petrol engine generally lies between
