Answer Posted / manoj
poles on s plane gives information about the system stability.If poles lies on right half of s plane system is unstable,if poles lies on left half of s plane system is stable,if poles lies on imaginary axis system is marginally stable.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the meaning of HT Trivector Meter ?
can the measured percentage error during calibration of single phase energy meter be negative?
which motor have relatively high power factor and what is reason for have high pf? 1.capacitor run motor 2.shaded pole motor 3.capacitor start motor 4.split phase motor
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
what is W.T?specify the acceptable range?
How can we checked Killo Watts of Motor & Alternator?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
what is the meaning of neutral displacement ???
How to perform a DC resistance test In Alternator and their proceduces?
What is resistance reading of earth copper rod with grid and without grid?
What is limitedly stable system?
What is turn ratio of a transformer?
what is the transiant condition in alternator? and how it can be prevanted?
What are locations arc protection relay is fixed.
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
