Interested to Buy Any Domain ? << Click Here >> for more details...
Which motor has high Staring current
A. Series DC motor, B.Induction motor c.Synchronous motor D.DC Shunt Motor
- 4 Answers
- 4775 Views
- CCP, I also Faced
- E-Mail Answers
Answer Posted / anil p. bhadjs
A series dc motor
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
HOW WE KNOW IN PHYSICALLY THE CONTACT SURFACE OF A VACUUM INTERRUPTER IS GOOD OR GOING TO DAMAGE IN A VCB AFTER ABOVE 500 TIMES OPERATED.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
What are PLC leader logic program method
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
12.5 tons a/c is their how much kva generator can recommend to the customer.
hr round
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
