In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and high expansion factor metal in bimetaliv strip?
- 1 Answers
- 2311 Views
- Process Control Technologies, I also Faced
- E-Mail Answers
Answer Posted / umar
Because of amplification of bending
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
What is difference between radial vibration and axial vibration explain in detail .
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
how to measure oxygen which methods are using?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
What is heating effect?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
There are many type of control cable like pair,core,tried, What are defination each one
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
which type inter lock use in petrochemical refinery,and oil & gas?
I wnat to practice more online type questions .so will you show them me to take a practice test?
