Answer Posted / pradeep chauhan
Killo volt ampere in Reactive power
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
How can we checked Killo Watts of Motor & Alternator?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
how to maintain frenquncy with syncronising sub-station for distribution
What is dielectric loss?
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
What is the function of capacitor in electrical circuits?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is stepper motor?
WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
