transformer is connected with 50hz and 60hz at same rating
which will give more output on same rating
- 2 Answers
- 3088 Views
- Palace Consultant, I also Faced
- E-Mail Answers
Answer Posted / rinkesh
both gives same output .... bcoz in xmer definition ...
It iz the device to stepup and step down the voltage
Without change in frequency ... so frequency iz not
Come in pictures in case of transformers
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
We have 750KVA DG set, we want to introduce REF relay with 1250/1A,CL PS,Current transformers.The lead distance of 2.5mm copper flexible cable from CT to relay is around 5mtrs.We would like to know the knee point votage(VK) & IM calculion for CT's
What is expention fastener (Fan)
Zone of protection and tripping scheme of arc protection relay.
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
why ht motors are star connected?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how can we phase identification in a distribution line,how we recognise that which phase is coming for a house hold connection.help me............
how many parameters can integrate with fire alarm basically ?
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
I want to know how to calculate the size of electricity cable in building?
