In a furnace, 2 chemical reactions are happening – 1 mole of solid carbon reacts with 1 mole of oxygen gas to generate 1 mole of carbon dioxide gas; 1 mole of solid carbon reacts with 0.5 mole of oxygen gas to generate 1 mole of carbon monoxide gas. In a given process, 100 kmol of carbon is burned in a furnace. (a) Calculate the theoretical oxygen gas needed by assuming that all the carbon is burned completely to carbon dioxide gas. (b) Calculate the theoretical air needed by assuming that all the carbon is burned completely to carbon dioxide gas and there is only 21 % of oxygen gas. (c) Determine the amount of air required (in kmol) if 50 % excess oxygen gas must be satisfied for (a) and (b). (d) It has latter been found that 20 % of the carbon undergoes incomplete combustion resulting to carbon monoxide gas production. The rest of the carbon undergoes complete combustion. Calculate the total oxygen gas required stoichiometrically based on the actual process.
- 1 Answers
- 1976 Views
- I also Faced
- E-Mail Answers
Answer Posted / kang chuen tat (malaysia - pen
(a) Theoretical oxygen gas = 100 kmol C (1/1) = 100 kmol of oxygen gas. (b) Theoretical air = (100 kmol) (1 / 0.21) = 476.2 kmol. (c) Amount of air required 50 % excess = 476.2 kmol (1.5) = 714.3 kmol. (d) Carbon consumption to produce carbon dioxide gas = 0.8 x 100 = 80 kmol = oxygen consumption to produce carbon dioxide gas. Carbon consumption to produce carbon monoxide gas = 0.2 x 100 = 20 kmol = 2 times oxygen consumption to produce carbon monoxide gas, then oxygen consumption to produce carbon monoxide gas = 20 / 2 = 10 kmol. Total oxygen gas required = 80 + 10 = 90 kmol. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the apt definitions for apparent power, active power and reactive power? Explain about different types of lamps?
Explain what are some good uses of low-grade steam at 12 atm and 1920c?
hi all i have doe cheical engg, but i have to go for iob po interview so can anybody suggest me abt the kind of qns that can be asked.
what is isochronus and droop speed?
Explain the factors involved in considering the choice of dry screw compressor?
sir i am appearing in railway exam of section engineer and my branch is chemical engineering i want previous question paper of section engineer of chemical branch please tell me as soon as possible my email id is surendrasaroj18@gmail.com THANKYOU
What industries require filtered compressed air?
Why in a continuous plant for a Hot standby screw pump system the interlock for auto starting of the other pump ( when the running pump stopped suddenly) is given with header pressure only? why not with flow rate or current of the pump?
Explain how can you estimate the efficiency of a pump?
What are some common problems associated with dilute phase pneumatic conveying?
Explain how can one estimate how the friction factor changes in heat exchanger tubes with a change in temperature?
could anyone send me model question papers or outline of graduate trainee(chemical engg) post?
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha?
What are advantages using hollow shaft impeller?
What is a good source of information for the design of pressure vessels?
