Why we. Don't measure current in parallel? Why we measure current in series and why we measure voltage in parallel only?
Answer Posted / alok
we know that ammeter has ideally zero resistance so if we connect it in parallel with the ckt then it will short ckt the device in which we are measuring the current.
and we know that voltmeter has large resistance so if we connect it in series then it will open the ckt and will prevent the flow of current.
Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
List three types Level Switches with their working principles
what is difference between HOT permit and cold permit
which type of signal used in instrument?
what is interlock system and why we use of this?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
what are the diff. in servo and regulatory control?
what are procedure of sox-nox calibration
In which principles tx ,pressure gauge,Temp gauge,control valve works?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Explain how thw analog to digital converter works with the circuit diagram
How to interfacing microcontroller with a DC motor
What is Cavitation in a control valve?
What is motion balance principle?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?