Answer Posted / venkadesh
because the transistor operating region range is 4-20 ma,these in between range is transmitter working in safe level
| Is This Answer Correct ? | 1 Yes | 11 No |
Post New Answer View All Answers
Boolean algebra
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Lux meter is the measuring device to measure the lux level of lighting fixture. in industrial sector two types of lighting fixture is being used as street lighting purpose 1. HPSV (Sodium) and 2. HPMV (Mercury). HPMV having white light which is an combination of red, blue and yellow colour, while HPSV haivng Yellow lighting. in HPSV red & blue colour will be absent. during measurement of the lux level of HPSV and HPMV fixture. 1. Lux meter can measure the actual lux level of both fixture? 2. or it will show false reading for HPSV fixture light as it has only yellow light present. please give me answer
how u calibrate pneumatic n motorized c/v?
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Why flow/pressure transmitter before control valve?
Why grounding is necessary? Give example with diagram.
which type of signal used in instrument?
Tr. Wiring for calibration.
Conversions
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
Why even multiple power supplu r used in instrumentation system?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
