Answer Posted / ashish shete
All the above answer is currect but question is that it is applicable only for ac or DC circuit or both?
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
why output is out of phase in case of common emitter?
Transformer diagram mention each parts ?
Battery is a voltage source? give one example of current source and why?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is high and low cut off voltage of BB and DG at SPS????????
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
Explain the working of any one cutting machine
what is (+) and (-) in generator field detector stand for?
What are the essential characteristics of signal flow graphs?
How cmd is calculated in case of energy neters
how solar power plant energy meter multiplication factor
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
