Interested to Buy Any Domain ? << Click Here >> for more details...
why not maintain Ph 7.0 in Boiler because 7 Ph is not acidic and not basic.
- 4 Answers
- 8862 Views
- Atlas Power, I also Faced
- E-Mail Answers
Answer Posted / narendra mishra
You have to keep ph slightly more than 7 so that if Ph gets down below 7 then we will have some time to raise it above 7.if we keep it at 7 & when it gets down to 6 then it will immediately become acidic.
| Is This Answer Correct ? | 15 Yes | 7 No |
Post New Answer View All Answers
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
By any way can we increase the B check hours from 300 to 500
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
why do you consider yourself a suitable candidate for this position
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
what is the meaning of SST300 V56A in SIEMENS turbine
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
why airtel use + 24 volts and other operators use -48 volt
what is the trip circuit supervision in an electrical meaning?
what is the difference between compensated & normal drum level in boiler drum?
procedure of how to generate power in solar plant.
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
what is natural frequency of turbine shaft .
