Answer Posted / er.mohit agrawal
Beam is strong in tension and weak in compression (steel takes only tension and concrete takes compression)
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
what is diffrence between catchment area,watershed and basin?
How much cement and water required for cement selery????
roll of DLC in road constructions
How much cement,sand,bricks and water needed for 1square metre brick work?
what is anchorage length,lap length and (dont remember the last one)
Can rice husk ash be used instead of coal fly ash for manufacture of clc/ foam concrete
how to calclate the SHUTTERING TAKEN CONCRETE LOAD? WHAT IS THE LOAD BEARING CAPACITY IN STEEL SHUTTERING PLATE? WHAT IS THE CONCRETE LOAD IN (MASS) IN THE SHUTTERING PLATE. PLATE SIZE IS 120CM* 90CM CONCRETE WALL LENGTH IS 10M ,WIDE IS 60CM, HEIGHT IS 1.2M PLS TO SENT THE CALCULATION.
For the construction project what capital cost has to be taken in consideration?
What is the zero value in quantity surveying
how to decide the mortar ratio 1:4,1:6 in masonry? same in plaster 1:3 and 1:4? which code or any document reference taken to define proportion?
Why are steel plates inserted inside bearings in elastomeric bearing?
What is the name of this multiplication factors ?
What is the difference between EPC,DBOOT and BOOT.
What is Curtailing of R/F
