What is reason to get a power factor nearly zero in resistive loads
- 2 Answers
- 3116 Views
- I also Faced
- E-Mail Answers
Answer Posted / sudipt jena
Absence of reactive power.
As we know series connection of inductor or capacitor leads to phase shifting of current with certain angle and hence decreasing the power factor of the line. But unlike capacitor/inductor a resistance is a passive element, resulting unity power factor.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
I am having a 42KW 3 phase electrical heating furnace, heating element is 80/20 nichrome material, my connections is made in such a way that 2 star connection compromising 2 coils per phase so totally 12 coils, shall if i use it unbalanced star condition (instead of 2 group of 3 phase or 1 group of 3 phase, connecting 4 phases of 5 phases) what will be the consequences and is it acceptable?
Initially, when the input is not equal to the output — what type of response is this?
EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS (FOR VOLTAGES & CURRENTS)
How to calculate the copper in HT motors if KW, RPM & Voltage is given
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
what is effect of 5amp fuse on 2mva pry protection of transformer
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
How to check the cable fault / hv test of transformer cable.
what is advertised hop count
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
Why are iron cores in transformers made laminated?
Why control of DC motor is simpler?
sugest any typical project ?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
