What is the working principle of sox, nox analyzer?(opacity monitor)
Otherwise how to measure the sox,nox?
Answer Posted / roshan t
SOx NOx meters have one reference gas cylinder on which first they calibrated then sample gas passes through this analyser where SOx gas volume measures against voltage in m3/kg or in ppm
also if u want then multiply m3/kg by 24.75 and divide it by its molecular weight u got ppm value
Is This Answer Correct ? | 14 Yes | 12 No |
Post New Answer View All Answers
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Why is the orifice tab provided?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
How ejector(or)evactor air pump is working in thermal power plant?
Why mixer nd grinder Is example of constant torque load not variable torque load ???
How to calibrate smoke Dectector
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
In turbine, what does term CDP, NI, NH, HSSOC, means
How hart protocol can be connected with control valves?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
defination of radial vibration?
any body please send me the old question papers of ongc test.
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?