why we are using the ac supply in domestic purpose why
don't use dc supply
- 6 Answers
- 14702 Views
- Airtel, SSIL, I also Faced
- E-Mail Answers
Answer Posted / nil de
in ac supply u can easly avail the transformer action to increase or decrease voltage level but in dc u can't avail the transformer action.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
how to protect motor in dol starter having capacity of 30 hp.40 hp?
what is model question rrb junior engineer electrical gr.II
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
What types of question are done for diploma students in aptitude test
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
How many VSC based HVDC are there in India and the world
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
Difference between a pilot wire and a normal conductor?
