What is the Difference between E/P Positioner and I/P
positioner in a control valve? In which applications the
respective positioners are used in?
- 18 Answers
- 70890 Views
- ADCO, I also Faced
- E-Mail Answers
Answer Posted / dinesh wanjari
I/P converter convert 4-20 mA input into 3-15 psi pneumatics output where as E/H converter convert electrical signal input into hydraulically pressure output as per design.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Positioner usage.
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
sir, give me placement papers and interview quistion of birla group company of copper.
what are the steps I have to deal with?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
what is the process for double acting cylinder pneumatic for 32' v/v
what is the minimum power (P=VI)to produce a spark?
what is performance test.need defination
what is sil (safety integrity level
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
If P will increase then what will happen with PID?
What is Predictive Maintenance
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
