what is difference between sub-station and switch yard.
- 16 Answers
- 100022 Views
- Bhel, Ravate, I also Faced
- E-Mail Answers
Answer Posted / alok
A switch yard connects one part of power system to another without changing the voltage level while a substation have a Transformer to change the voltage Level(it have almost all the equipment same as switch yards)
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
how can we design robots
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
how is working bearing heater?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What is negative sequence over voltage element?
What is line resistance of cable & how it can be measured ?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
is it value of power factor is more than unit. whats effects in the source supply
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
What is Servo Ventilated Motor?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
which type of questions asking for solar companies?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
