Answer Posted / deoghar
Total Length is : 50.00mtr
Cutting length : 6.00mtr
Dia of Bar : 32mm
Then no of lap is is
50.00-6.00=46.00mtr
46.00/4.400 ( 4.4000 is length of bar without development length)
= 10.450+1 = 11.450nos
Say 11 nos laps
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
Explain moment of inertia and its importance.
How to calculate the area in squarefeets ?How much area of sqft for this measurements?East 53.3ft West 54ft North 47.7ft South 51.1ft ?
which red: used in roof teping, then use only cement
what is the Asfalt test?in road constraction..?
Minimum concrete cover in slabs, columns, beams, foundation and other st?
CAN WORK WELL UNDER DEAD LINES OR PRESSURE?
Can inverted beams used in pipes during construction?
how many digree of freedom in four bar chain
what is floating slab foundation?
Hi how r u ? hope you are fine there . Please can u tell me tha Design life of Buildings as Per ACI CODE 318-99. It will be a pleasure for me .Thanks in advance
Would you cause a 55-gallon drum of water to weigh more by climbing in?
What does a construction cost covers and what does not?
Define graphics window?
What applicable rate of wct in bihar
