The power dissipated by a resistor of 10ohm when a current of 2A passes through it is:(a) 0.4W(b) 20W(c) 40W(d) 200W
- 2 Answers
- 4725 Views
- I also Faced
- E-Mail Answers
Post New Answer View All Answers
he compression ratio for a petrol engine generally lies between
What are the properties of a resistor?
What is step signal?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
How to calculate impedance volt in Transformer?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
Calculate torque developed by the 3-phase, 5 H.P., 4 pole induction motor runs at 1500 rpm A 23 N-m B 21 N-m C 10 N-m D 0 N-m
HOW MANY TYPES OF FUSE?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
What is the disadvantage in proportional controller?
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
why are distributed windings generally used in alternators?
