Electromotive force is provided by:(a) Resistance’s(b) A conducting path(c) An electric current(d) An electrical supply source
- 2 Answers
- 4098 Views
- I also Faced
- E-Mail Answers
Answer Posted / dheeraj.yadav
A conducting path and electrical supply source
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
Why High voltage are generate noise ?
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
what are inherent currents?
If we want to change a contactor of faulty one what are the conditions want to fullfil
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
Graphs of measuring power and speed on dc motor
What is VCB? where it is installed at SP. What is SP?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
How to calculate energy stored in a capacitance
Differenciate between circuit wiring and sub main wiring with illustrations
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
