Rccb trip or not with out neutral connect in three phase welding machine
- 1 Answers
- 3349 Views
- I also Faced
- E-Mail Answers
Answer Posted / dheeraj.yadav
Rccb connected in circuit for protection against earth fault.whether neutral connected or not.if any phase is earthed then Rccb triped.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
physical identification of HT & LT panel
hi....I am from india..i have completed my engineering in electrical and electronics field with 58.4% and my IELTS score is 5.5 bands....Recently i received my I-20 in computer and information science from Troy university in Alabama.On 18th i have a visa interview can u please tell me what type of questions i have to answer ??????
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
What is the general power factor & min. power rating of TV,LCD type TV, CRt type TV, Scanner, printer?
What is open delta Xformer? It's adavntages & Use?
EXPLAIN THE TRANSFORMER MAINTENANCE?
number of I/O devices in siemense plc
what are the installation procedure of high voltage power transformer,CT,CB&PT?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
Where should the lighting arrestor be placed in distribution lines?
What is the difference between the impedance percent and impedance voltage ?
What is VCB? where it is installed at SP. What is SP?
We have two parts in generator, electrical & mechanical. how it works?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
