Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are using thrust bearing at turbine side?
- 3 Answers
- 4922 Views
- Edac, I also Faced
- E-Mail Answers
Answer Posted / manan2347
To withstand the axial load we are using thrust bearing in turbine.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how to calibrate and troubleshooting of leveltroll?
Pl send the model question paper of mahagenco account officer post
What is zener diode? What is voltage regulator?
what is the reset offset and control system in instrumentation
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Explain Gas Turbine startup and shutdown sequences
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
Conversions
How to Calibrate Radar Level Transmitter in Field
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
