Answer Posted / kranti1986

The method used to calibrate a magnetic flow transmitter is Dry Calibration, in which we use a calibrator(usually called as Simulator, provided by the vendor)connected to the transmitter and increase the knob in steps.
If there is any error we can adjust

How to calibrate Field bus transmitter? procedure ?

2355

---

What are different types of cable?

1099

---

How we calculate orifice plat size???

1538

---

use of split range ? where it is used ? in which control loop it is used ?

1978

---

Tr. Wiring for calibration.

2077

---

Why do we have earthing cable in branch cable and shield in the same cable?

2613

---

why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

2456

---

What is zener diode? What is voltage regulator?

1108

---

how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

2228

---

What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?

2030

---

hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....

2610

---

Question on maha cement

748

---

Linear amplifier.

2032

---

If fire would be inside the plant which fire detector is to detected the fire.

1613

---

How an rtd work, and what volts/current goes to a rtd to measure the resistance?

1287

---