1. what is difference between VCB and ACB.how its works
please explian.
Answer Posted / anil kumar
Sorry all
CT are use the low voltage line
CT not use high voltage line We are use the pt in the high voltage
Is This Answer Correct ? | 9 Yes | 10 No |
Post New Answer View All Answers
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
explain the Trip supervision circuit
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
can i able to get bhel previous exam question paper?
electrical ques
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
Difference between transition and diffusion capacitance
what is physical distance of isolator to VCB in 33/11kv sub stations
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
how is the testing of an REF relay? what are the test REF circuit having?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is power factor why we should maintain the power factor unless what will happen
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
If we want to change a contactor of faulty one what are the conditions want to fullfil