Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pramod
in normal power system, if load is connected to only one common bus,then whole load depend on it. But, if load is connected in ring system, like ring main system, then if one section getting fault, then other will capable to supply power. So, it is more important for reliability of power supply
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
Safety of on line ups
What are the main significances of root locus?
How to measure the Harmonic Distortion of UPS ie THD?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
what is alluminium arm in ab conductors
What is the type of feedback used in an op- amp schmitt trigger?
Form S and "c" license application both are same? @ tneb portal
Showing results for capital, machinery, stock,wages, carriage in words, salaries, factory rent, repairs, fuel and power, buildings, debtors, sales, purchases, creditors, return outwords, return inwords, drawings, discount allowed, discount receivable, office expenses, bills payable, bills receivable, cash in hand, cash at bank, office rent comes under debit or credit
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
how to deside the capacity of chock for drive?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
Differentiate between voltage and current feedback in amplifiers?
