Answer Posted / satya prakash devagupthapu
the exciter coil of alternators fails due to
1)when the diode plate not properly work at the back of alternator which is connected to compound wound generator rotor.(the exciter field coil connections of alternator are connected to compound wound generator rotor).
2)and major reason is AVR failures also.
To avoid these failures of components maintain equal and correct load on each phase of the generator.
and avoid loose connections at the diode plate terminals.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Pl. share your experience about industrial-electronics repair of machine tool.
How to calculate cable rating for 3 phase supply?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
What is the source of dependent source ?
Define cut-off rate?
what is die electric strnth of transformer ?
What is the difference between indoor and outdoor transformer
Define damping ratio.
How to Calculate the Fault Level of Electrical Installation
how we can calculate chiller required ampear?
what things to be considered when designing UPS
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
