How can I map a tank?
Tank 15m h and 42m dia.
we just fixed radar type lit.
its reading shows over range.
Now its required mapping ?
- 1 Answers
- 2670 Views
- CMC, I also Faced
- E-Mail Answers
Answer Posted / gp
Radar LT measure the distance, so two options to map,
one is Empty mapping of tank and other is the partial mapping of the tank level. The second option is useful while you are sure the liquid level in the tank
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
what is the importance of CV in the control valves? how it is calculated?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
What is the minimum rating availalbe for weld neck orifice in market?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Capacitance, resistance ( colour coding ), parallel & series circuits.
Explain operation of Haskel pump.
flow transmitter formula?
