Interested to Buy Any Domain ? << Click Here >> for more details...
Sir, Please tell me that how I will calculate the efficiency of rectifier. Because input is ac and output is dc. Is it right to put two unlike signal together.
- 2 Answers
- 3097 Views
- I also Faced
- E-Mail Answers
Answer Posted / pritish
Deal all
we know the input to the rectifier is ac and output is dc so it is not possible to calculate the power factor in conventional analysis abecause the source ttransformer oor tthe supply contains iharmonics aand hence we cannot determine tthe supply actual angle between tvoltage and current.
Hence the power factorfactor canbe calculated aas input power frfactor which is the product of adisplacement efactor and distortion factor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
i installed 100kva ups. what KVA genset they should provid in input side? plz any update formula or ans with reason.
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
Why the cores of large transformers build up of circular cross section?
what is per unit calculation?looking for simple and strong explanation thk u
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
bus bar design conditions and sizing pls tell me quickly
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
How many types of circuit loads are there in a common electrical circuit?
