Answer Posted / achal
As DC is has constant frequency it creates constant flux, hence.
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
wat is the first thing dat is needed, 2 lay a cable in some area??
What will be the diameter of pipe between conservation tank and transformer
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
State the types of distortions in amplifier?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
how to identify the cable quality and what is flame proof cable
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
harmonics filter
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
what is the function of Moulded case circuit breaker, why it is called Moulded?
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?