why ELCB can't work if N input of ELCB do not connect to
ground?
- 5 Answers
- 23710 Views
- I also Faced
- E-Mail Answers
Answer Posted / mayuur
There is no need of connection to ground because there is two current pass which are passed in oppose direction so the flux in the coil has been nullyfied .
And if u connected n terminal into ground there the relay trip immediatly
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
Who are the manufactures those manufacturing 3Cx2.5sqmm FRLS cables. I heard about FRLS technology adopted only in wires useful for wirings
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
explain comutator action in detail.thanks
How phase displacement change in the over current relay coils.
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
How to set a Zone 1 distance relay for distribution feeder?
What is the ratio of Booster transformer?
which is better to use svc or synchronous condenser why ?
What is meant by a stray loss of a induction motor??? What is the equation to find it
how is find out kwh step by step
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
Starting current of a 10 HP induction Motor is ______ time’s full load current.
what happens if dc supply is given and the remedies for it.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
