how can you measure wt. of G.I.pipes knowing od,id,length.
- 3 Answers
- 12053 Views
- Vertex, I also Faced
- E-Mail Answers
Answer Posted / rahul nayak
PI x ID (m)x Thickness (mm)x Density (7.85 kg/m3)x Length of pipe (m)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
en 19 & en24 which one is good for pipe mill shaft
What are the requirements of a good fuel?
can i use IS 2062 gr B pipes in the softening plant pipings?
what is the advantages and dis advantages of critical speed of turbine.
what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?
Out of electric heater and heat pump, which is economical in operation ?
What is pulse tube used in low temperature application?
What is viscosity and why is it important?
if any one who attended the caterpillar interview please send me the sample questions and the areas from which questions are being asked...
Hi any one can help in preparing for BHEL ET exam in mechanical stream? I like to know the the question paper pattern fro the same. regards, Jose 9841327666 josevinoth@yahoo.com
if the blade height is increased,then how it increases the specific speed of centrifugal pump?
What do you treat in high alkalinity of boiler water? What is a feed water pump? What is a Booster pump?
WHat is adsl?
At 50 Centigrade (Diesel oil) what is its cast?
What is coefficient of contraction?
