We order Dyn 5 distribution transformer to a company. What arrives is Dyn 11. Is it ok to use this transformer.
It will be installed alone.
Answer Posted / koti1965
If it is a standalone installation and for general purpose Dy11 is OK. But why you have ordered Dy5.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
What is dynamo?How it works and what is the function of dynamo in a DG.
WHAT IS MEANT BY DERATING OF THYRISTOR?
why they were using TRIAC instead relay in some controllers and what is the advantages.
Explain The Application Of Storage Batteries?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What is the purpose of stablization resistor in high impedance bus bar protection
What cmos is and its benefits?
Explain dc generator with its types?
Why CBCT rating is 50/1A
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
How does the phase sequence controller works, how it identifies the phases? confirm working principle
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?