SUPPOSE A CIRCUIT BREAKER HAS TRIPPED THE THE LINE WHEN A
FAULT OCCUR ON IT.NOW WHEN THE FAULT HAS BEEN CLEARED, HOW
THE CIRCUIT BREAKER WILL CLOSE AUTOMATICALLY NOT MANUALLY.
- 6 Answers
- 6928 Views
- Bureau of Energy Efficiency, DVC, I also Faced
- E-Mail Answers
Answer Posted / mg
There is autoreclose function in protection relay(autoreclose relays) if fault is cleared the relay give close command to CKT breaker.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
What is the operating principle of turbo-generator.
what is the meaning of vcc
what happen when we add mentos in cold drink?& why?
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
What is Fire Panel ? How it works ?
wat is meant by PX class in ct?
What information we need to prepare relay coordination chart
what is a vector protection in transformer
How to calculate the phase to phase clearness of HT /// LT bus bar?????
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
How shall i select the value of capacitor or inductor in a system?
what is the effect of un-synchronized power.
What is order of the system?
