40 HP motor how many square mm size wire use for stator to motor & aluminium wire use ?
Answer Posted / balaji
35 sq.mm aluminum
Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
what material is used in capaciter
before synchronizing an alternator,power factor is leading ,why?
What is Antipumping Function & If we have C.T how we find the Ratio ?
Why the arms of delta in a delta-wye power transmission system are kept constant??
What are the advantages of the three-phase motor over single phase motor?
How do we calculate transformer oil in liter from the rating of the transformer.
give me atleast four differences between circuit and network
What is vacuum circuit breaker.define with cause and where be use it device?
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
Starting Time of LT & HT Motor
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
What is the effect of pi controller on the system performance?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
what are the parameters plays a major role in Potential transformer Burden calculation??